Membrane valve for cover Porsche engine 3.6 M55.01 – $24.90

Diaphragm membrane valve cover Porsche 95510513501, 95510513500, 95810513530.
Engine 3.6S M55.01
213kw / 290 hp

pcv ccv pvc
manufacturer produces only cover assembly.
we make the membrane separately!
your savings is more than $ 350 (the cost of our membrane, compared to the price of a new cover and work to replace).

Over time, the diaphragm valve of ventilation of crankcase gases and drying tears.
Torn through the membrane into the engine misses unaccounted mass air flow sensor.
As a result, the engine can be difficult to start, unstable work (especially at idle) may be misfiring, as the engine can get dust, which contributes to the deterioration of parts and mechanisms.
If the whistle is heard in the area of ​​finding the separator, then the membrane is torn.

Manufacturer sells only the valve cover assembly cost, which is $400.

We produce and sell this membrane separately.

Instructions for Replacement:
Remove the valve cover.
Remove the vent valve crankcase gases (installed inside the valve cover).
Remove the cover membrane, set the new replacements poor membrane.
Reassemble in reverse order.

During the first run, after replacing the diaphragm, the engine can not operate stably
(this is due to the fact that when the membrane was torn fuel cards to reconfigure the computer, in accordance with the lambda probe, which recorded the high content of oxygen).
After replacing the membrane restores the valve, as well as eliminating the choke unaccounted air, computer needs some time to adjust fuel cards.
It is necessary to give the engine run for a while, turn off the ignition and start again, the engine must reach normal operation.