Brass Gear Power Seat Motor
1 lot – 1 pcs
Available is here the repair kit (brass gear) for the seat adjustment
Buick Park Avenue
Chevrolet / GMC Sierra
Chevrolet / GMC Silverado
Chevrolet / GMC Suburban
Chevrolet / GMC Tahoe
Chevrolet / GMC Yukon
Chrysler Town and Country
Chrysler Voyager
Dodge Grand Voyager
Dodge Ram
Jeep Cherokee
Jeep Grand Cherokee
Winnebago Adventurer
The original electric seat adjustment device is made of plastic and often breaks. When the plastic teeth strip from the drive, the gear will not turn. The motor continues to buzz but the seat does not move. The dealer will have more than $ 400 only for a completely motor without Assembling.
The small plastic drive gear is not available to buy.
But you can get my solution in a brass version and the drive gear will never destroyed in future. Brass is an special metal for high firmness in comparison to plastic.
The assembling can be done by yourself. The old plastic drive gear must be removed with a tong or small saw and after that a small thread behind must be whet. At the end you must drill a hole for the fixation and assemble the brass gear.
Included with your purchase are written instructions and illustrations to assure completion of this simple do-it-yourself project which can be done in short time.
The gear fits following units:
1997 – 2004 Jeep Cherokee / Grand Cherokee Power Seat Parts
Part number non-memory: Gen II B Vertical, 8-82494, 5709790
Part number memory: Gen II B Vertical, 8-82496, 5709820
1995 – 2008 Dodge Ram Power Seat Parts. These parts are for 1500, 2500, 3500
Part number Up/Down Adjustment front Motor: Gen II B Vertical, 8-82991, 5609780 or 5719240
Part number Up/Down Adjustment rear Motor: Gen II B Vertical, 8-82992, 5609820 or 5719230
Part number Up/Down Adjustment for front and rear Motor Gen II B Vertical, 8-81902, 5709440
2004 – 2006 Dodge Town and Country Power Seat Parts
Part number Up/Down Adjustment for front and rear Motor: Gen II B Vertical, 8-82494, 5709790
2005 Winnebago Adventurer Power Seat Parts
Part number Up/Down Adjustment for front and rear Motor: Gen II B Vertical, 8-81902, 5709440
High Quality producer !
Instructions for Replacement:
Remove the driver’s seat.
To do this, unscrew the 2 screws at the front and four in rear, unscrew the belt from the seat.
Turning off the battery and disconnect block with wires.
Now you can get the rest of the interior of the car.
Remove and disassemble the drive
Removed electric drive
Gear teeth are broken
Remove a broken plastic gear.
Grind the remaining metal prongs to firmly install the new gear.
Drilled through it all and trying to drive a thin drill lock (so the gear does not scroll).
Inside the drive add grease and assemble back.
The end!